Custom Angled Landing Fabrication


Product ID : CustomAngledLandingFabrication

Price: $195.00
Custom Fabricated Landing
Left when ascending staircase
Right when ascending staircase
Single Turn Angled Landing - see photo examples - Please Include Any Additional Info Below

Ask a Question


How do I order a Custom Landing? The first step to order this service is to establish the footage need for your project. One component needed is runner product choice since pattern repeat is a variable affecting footage.  Please submit the form below to begin this process - we will reply with the footage needed and costs associated with the project:     Click here to fill out our Single Turn Angled Landing Quote Form

Please Contact Us or Call for more details. 

All Custom Fabrication work is completed by Owner, John Hunyadi   Click here to see more examples of John's Angled Landing Work 
A landing that has an angle shape requires custom fabrication to match that angle. Angled landings often consist of just a single turn, but can also be "U" shaped - which reqires additonal fabrication work, information and increases cost. In any case we will need a paper template sent to us to create the correct shape for your landing. Please Contact us to go over the details of your runner project.

Shipped Landing Fabrication Details:

 - Footage is based on customer supplied data/photos, landing dimensions/stair counts and using 19 inches of material for each step which is tread + riser total. This is a safe number with few exceptions. Please let us know if your stairs when measured are larger than this.  (often a tread is 10 to 11" deep, riser is often 6 to 7" high and when wrapping the nose a total step measurement will be 18 to 18.5") 
 - Landing fabrication causes waste due to pattern repeat, pattern placement and the incremental nature of stairs - your final roll will not be the full length ordered, but footage has been calculated based on your data to accommodate the project you've described and with this waste in mind. 
 - A fabricated landing will be shipped at the top end of the runner footage roll. It is intended to be installed first, working down the stairs below the landing. *The remaining footage is cut on site at the bottom of the lowest riser (where it meets the 1st floor) This material is then brought up to be installed on the stairs above the landing. In the case of multiple landings, the same process applies, footage is left on each landing to work down from it, with additional footage to be brought up to the stairs at the top of the staircase - we will provide further details as needed.  *This can cause an interuption in the pattern but tends to be at a less visible point in a staircase. Please Contact Us with any questions about your specific project and runner product.

 - Shipping:  Most Custom Angled landing orders total over $500 so will ship for free.  Although uncommon - some fabrications result in an oversize package, and will incur an added shipping fee, determined on a case by case basis. (this fee will represent the difference in our cost over that of the amount we regularly absorb with our free shipping  policy on most orders over $500)